Cisco 15310-MA Instrukcja Naprawy Pobierz pdf (Strona 354)

4-46

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-6087 The card cannot be changed because the card type is invalid or

incompatible.

Refer to the error message text.

EID-6088 This line cannot be put into loopback while it is in use as a

timing source.

Refer to the error message text.

EID-6089 The interface was not found. {0} CTC cannot find the specified interface.

EID-6090 The interface type is not valid for this operation. {0} Choose another interface.

EID-6091 The current state of the interface prohibits this operation. {0} The port is in an invalid state to set a

loopback.

EID-6092 This operation is prohibited for this interface. {0} CTC does not allow this operation for the

specified interface.

EID-6093 The maximum number of TARP data cache entries has been

exceeded.

You have exceeded the number of

characters permitted.

EID-6094 The maximum number of manual adjacency table entries has

been exceeded.

Refer to the error message text.

EID-6095 The AIS/Squelch mode is invalid. Refer to the error message text.

EID-6096 A default IP-over-CLNS tunnel route is only allowed on a node

without a default static route and a default router of 0.0.0.0.

Refer to the error message text.

EID-6097 The authorization key does not comply with Cisco IOS

password restrictions.

{0}

Specify another authorization key.

EID-6098 A default static route is not allowed when a default

IP-over-CLNS tunnel exists.

Refer to the error message text.

EID-6099 You cannot create a subnet on a disabled router. Create the subnet on an active router.

WID-6100 Disabling a router that has a provisioned subnet is not

recommended.

Refer to the warning message text.

EID-6101 The MAT entry already exists. Refer to the error message text.

WID-6102 The new card has less bandwidth than the current card. Circuits

of size VT15 and larger will be deleted.

Refer to the warning message text.

EID-6103 The TDC entry already exists. Specify another entry for TARP Data

Cache.

EID-6104 APC ABORTED. Automatic Power Control is aborted.

EID-6105 The 'Change Card' command is valid for MRC cards only when

Port 1 is the sole provisioned port.

Refer to the error message text.

EID-6106 To delete all RADIUS server entries, RADIUS authentication

must be disabled.

Disable Radius authentication and proceed.

EID-6107 The node failed to restart the TELNET service on the selected

port. Try using another unreserved port that is not being used

within the following ranges:

23, 1001-9999 (with the exception of 1080, 2001-2017, 2361,

3081-3083, 4001-4017, 4022, 4081, 4083, 5000, 5001, 7200,

9100, 9300, 9401).

Refer to the error message text.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 349 350 351 352 353 354 355 356 357 358 359 ... 379 380

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco 15310-MA Instrukcja Naprawy Strona 354

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco 15310-MA