Cisco 15310-MA Instrukcja Naprawy Pobierz pdf (Strona 164)

2-34

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

Note This condition is only reported if the path protection is set up for revertive switching.

Clear the AUTOSW-SFBER Condition

Step 1 Complete the “Clear the SF-P Condition” procedure on page 2-135.

Step 2 If the condition does not clear, log into the Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.30 AUTOSW-UNEQ (STSMON)

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

SONET Logical Object: STSMON

The Automatic Path Protection Switch Caused by Unequipped condition indicates that an UNEQ alarm

caused automatic UPSR protection switching to occur (see the “UNEQ-P” condition on page 2-151). If

the UPSR is configured for revertive switching, it reverts to the working path after the fault clears.

Note This condition is only reported if the path protection is set up for revertive switching.

Clear the AUTOSW-UNEQ (STSMON) Condition

Step 1 Complete the “Clear the UNEQ-P Alarm” procedure on page 2-151.

Step 2 If the condition does not clear, log into the Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.31 AUTOSW-UNEQ (VT-MON)

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

SONET Logical Object: VT-MON

The automatic path protection switch caused by an unequipped condition (VT-MON) indicates that the

“UNEQ-V” alarm on page 2-153 alarm caused automatic UPSR protection switching to occur. If the

UPSR is configured for revertive switching, it reverts to the working path after the fault clears.

Note This condition is only reported if the path protection is set up for revertive switching.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 379 380

Brak uwag

Cisco 15310-MA Instrukcja Naprawy Strona 164