Cisco 15310-MA Instrukcja Naprawy Strona 195

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 194
2-65
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 2 Alarm Troubleshooting
Alarm Procedures
Step 2 Log into the node that links directly to the port reporting the FE condition.
Step 3 Clear the main alarm. Refer to the appropriate alarm section in this chapter for troubleshooting
instructions.
Step 4 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
2.7.77 FE-DS1-SA
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: DS3
The Far End DS-1 Equipment Failure Service Affecting condition occurs when there is a far-end
equipment failure on a 15310-CL-CTX, ONS 15310-MA DS1-28/DS3-EC1-3, or ONS 15310-MA
DS1-84/DS3-EC1-3 DS-1 port that affects service because traffic is unable to switch to the protect port.
Clear the FE-DS1-SA Condition
Step 1 To troubleshoot an FE condition, determine which node and card link directly to the port reporting the
FE alarm.
Step 2 Log into the node that links directly to the port reporting the FE condition.
Step 3 Clear the main alarm. Refer to the appropriate alarm section in this chapter for troubleshooting
instructions.
Step 4 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
2.7.78 FE-DS1-SNGLLOS
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: DS3
The Far-End Single DS-1 LOS condition occurs when a single DS-1 signal is lost on a far-end
15310-CL-CTX, ONS 15310-MA DS1-28/DS3-EC1-3, or ONS 15310-MA DS1-84/DS3-EC1-3 DS-1
port (within a DS3). Signal loss also causes the “LOS (OCN)” alarm on page 2-106.
Clear the FE-DS1-SNGLLOS Condition
Step 1 To troubleshoot an FE condition, determine which node and card link directly to the card reporting the
FE condition.
Step 2 Log into the node that links directly to the port reporting the FE condition.
Step 3 Clear the main alarm. Refer to the appropriate alarm section in this chapter for troubleshooting
instructions.
Przeglądanie stron 194
1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 379 380

Komentarze do niniejszej Instrukcji

Brak uwag