Cisco NM-16ESW - EtherSwitch Switch Instrukcja Użytkownika Pobierz pdf (Strona 8)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

Configuring VLAN Trunking Protocol

This section describes how to configure the VLAN Trunking Protocol (VTP) on an EtherSwitch EHWIC,

and contains the following sections:

• Configuring a VTP Server, page 8

• Configuring a VTP Client, page 9

• Disabling VTP (VTP Transparent Mode), page 9

• Verifying VTP, page 10

Note VTP pruning is not supported by EtherSwitch EHWICs.

Configuring a VTP Server

When a switch is in VTP server mode, you can change the VLAN configuration and have it propagate

throughout the network.

Beginning in global configuration mode, follow these steps to configure the switch as a VTP server.

SUMMARY STEPS

1. vtp mode server

2. vtp domain domain_name

3. vtp password password_value

4. exit

DETAILED STEPS

Command Purpose

Step 1

vtp mode server

Example:

Router(config)#vtp mode server

Configures the switch as a VTP server.

Step 2

vtp domain domain_name

Example:

Router(config)#vtp domain domain1

Defines the VTP domain name, which can be up to 32 characters

long.

Step 3

vtp password password_value

Example:

Router(config)#vtp password password1

(Optional) Sets a password, which can be from 8 to 64 characters

long, for the VTP domain.

Step 4

exit

Example:

Router(config)#exit

Exits global configuration mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 89 90

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco NM-16ESW - EtherSwitch Switch Instrukcja Użytkownika Strona 8

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco NM-16ESW - EtherSwitch Switch