Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Arkusz Danych Pobierz pdf (Strona 152)

642 -531

Leading the way in IT testing and certification tools, www.testking.com

- 152 -

You work as a network security administrator at TestKing.com. TestKing is now

installing new Cisco IDS Sensors. You are required to configure these new Sensors so

that they allow remote access only from hosts that are trusted. You must execute this

task on of the IDS Sensors using the CLI (Command Line Interface). Use the

information below and the network topology exhibit.

Permit access from IDS MC management station only to the sensor.

NOTICE: As this is a new installation, you must also remove the default allowed

network address.

You are also required to verify your configuration settings before you save them. When

you have saved the configuration you are finished.

Cisco IDS Parameters Settings

Sensor operator username/password Testkingoperator/testking789

Sensor administrator username password Testkingadmin/testking789

Sensor IP address 172.16.30.31/24

Default allowed network address 10.0.0.0/8

Assignment: Click on the picture of the host connected to an IDS Sensor by a serial

console cable shown in the diagram as a dotted line. Select the Cisco Terminal Option

and make the appropriate configuration tasks.

ANSWER:

a. Enter configure terminal mode:

sensor# configure terminal

b. Enter host configuration mode:

sensor(config)# service host

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 167 168

Brak uwag

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Arkusz Danych Strona 152