
642 -531
Leading the way in IT testing and certification tools, www.testking.com
- 149 -
You work as network security administrator at the TestKing.com office in Washington
DC. TestKing is now installing new Cisco IDS Sensors and you are responsible to
configure them to permit remote access only from trusted hosts. Perform this task on
one of the Sensors using the CLI (Command Line Interface). Refer to the following
information and network topology exhibit to permit access from the IDS MC
management station only to the Sensor.
Note: Since this is a new installation, you will also need to remove the default allowed
network address. Verify your configuration settings prior to saving, and the save your
configuration when finished.
Cisco IDS Paramaters Settings
Sensor operator username/password testkingop/testking1918
Sensor administrator username/password testkingadmin/testking1918
Sensor IP address: 192.168.1.50/24
Default allowed network address: 10.0.0.0/8
Task: Click on the picture of the host connected to an IDS Sensor by a serial console
cable shown in the diagram as a dotted line. Select the Cisco Terminal Option and make
the appropriate configuration tasks.
Answer:
sensor#configure terminal
sensor(config)#service host (Enters Host Configuration mode)
Komentarze do niniejszej Instrukcji