Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Instrukcja Użytkownika Strona 302

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 398
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 301
748
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: There is no workaround.
CSCsm15406
Symptoms: Spurious memory access is observed when router boots up.
Condition: Occurs when Virtual Private LAN Services (VPLS) is configured. Observed in a setup
with 4,000 VFIs and about 8,000 VCs.
Workaround: There is no workaround.
CSCsm15687
Symptoms: Configuration of the crypto connect vlan <x> command may fail when the command
is applied to a dot1q subinterface.
Conditions: Occurs on a system with 7600-SIP-600 line cards and GE SPAs installed.
Workaround: There is no workaround.
CSCsm16309
Symptoms: Crash in Bidirectional Forwarding Detection (BFD) subsystem may occur after last BFD
session is removed.
Conditions: Occurs after all BFD sessions are removed and the BFD finishes cleaning up data
structures.
Workaround: There is no workaround.
CSCsm17066
Symptoms: One of the GLBP forwarders for a group may experience a state flap between two of the
group members.
Conditions: The symptom is observed after SSO occurs on a router in which the pre switch-over
state for GLBP is "LISTEN". The forwarder which is assigned to this group member will experience
the flap. It will only occur on setups where there are more than two GLBP group members.
Workaround: There is no workaround.
CSCsm17213
Symptoms: Packet loss/connectivity issues in a IPv4 VRF due to traffic being sent to the rate-limiter
and the VLAN-RAM table not being installed correctly. This is seen on interfaces which had an IPv6
address configured on it before.
Conditions: - The VRF needs to be configured for 6vPE and IPv4. - The 6vPE needs to be removed
from the VRF definition by the no address-family ipv6.
Workaround: Shut/no shut the VLAN interface.
CSCsm19663
Symptoms: A router crashes when MPLS VPN configurations are applied.
Conditions: This symptom is observed with the following configuration:
Router(config-if)# interface a1/0.1 point-to-point Router(config-subif)# mpls ip
Router(config-subif)# mpls label protocol ldp Router(config-subif)# ip address
10.0.0.2 255.0.0.0 Router(config-subif)# no ipv6 address Router(config-subif)# ip
split-horizon Router(config-subif)# pvc 6/100 Router(config-if-atm-vc)# encaps
aal5snap Router(config-if-atm-vc)# exit Router(config-subif)# no shut
Workaround: There is no workaround.
CSCsm20102
Symptoms: Sending traffic at a rate of 70 percent across large number of Multilink PPP (MLPPP)
bundles may result in a 0.4 to 2.5 percent loss of traffic.
Przeglądanie stron 301
1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 397 398

Komentarze do niniejszej Instrukcji

Brak uwag