
654
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
• CSCsu94864
Symptoms: The MLS shortcut for a user-traffic flow based on RADIUS Framed-IP (FIP) is not
purged when the FIP sticky times out. RADIUS Load Balancing (RLB) sends out a purge request
before deleting sticky and has no effect in deleting the MLS shortcut entry.
Conditions: Occurs on a device configured with RLB and FIP sticky idle timer and with MLS aging
timer configured higher than the RLB FIP sticky idle timer.
Workaround: There is no workaround.
• CSCsu96649
Symptoms: On Cisco 7600 with RSP720-3C-10GE processor, if the SIP-400 is configured as Lawful
Intercept (LI) service module after a line card online insertion and removal (OIR), the SIP-400 may
not get selected as Lawful Intercept service module.
Conditions: Occurs when the SIP-400 is configured as Lawful Intercept service module on the Cisco
7600.
Workaround: After line card OIR, select the SIP-400 again as the LI service module using the
command li-slot list <sip400 slot number>.
• CSCsu96730
Symptoms: Intelligent Services Gateway (ISG) traffic from one user to another may fail if the packet
needs to be processed by the RP in a Cisco 7600.
Conditions: Occurs when ISG is configured and packets are switched from one subscriber to a
second subscriber.
Other symptoms : - Counters of packet transfer might show difference between user transferring
between each other - Access-list might fail to block the packet
The 2 above symptoms will be seen when user are sending receiving on the same interface via the
ISG
Workaround: There is no workaround.
• CSCsv00168
Symptoms: Junk values are being displayed on the router when characters/commands are inputted.
For example, enter "enable", it shows "na^@^@"; enter "show version", it shows "h
^v^@e^@^r^@^@^@^@^@".
Conditions: The symptoms are observed with Cisco IOS Release 12.4(23.2)T.
Workaround: There is no workaround.
Further Problem Description: The CLI function is not affected by the junk values.
• CSCsv03300
Symptoms: Cisco 7200 NPEG2 router crashes while displaying the interface output for onboard
gigabit ethernet using the show interface gig0/x command.
Conditions: Occurs when a CBWFQ QoS policy is attached to the onboard gigabitethernet interface.
Workaround: There is no workaround.
• CSCsv04674
Symptoms: The M(andatory)-Bit is not set in Random Vector AVP, which is a must according to
RFC2661.
Conditions: This symptom is observed with Egress ICCN packet with Random Vector AVP during
session establishment.
Komentarze do niniejszej Instrukcji