Cisco 4510R - Catalyst Switch Instrukcja Użytkownika Pobierz pdf (Strona 9)

Available system uptime = 2 days, 2 hours, 39 minutes

Switchovers system experienced = 0

Standby failures = 0

Last switchover reason = none

Hardware Mode = Duplex

Configured Redundancy Mode = Stateful Switchover

Operating Redundancy Mode = Stateful Switchover

Maintenance Mode = Disabled

Communications = Up

Current Processor Information :

Active Location = slot 1

Current Software state = ACTIVE

Uptime in current state = 2 days, 2 hours, 39 minutes

Image Version = Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000−I5S−M), Version 12.2(20)EWA(3

.92), CISCO INTERNAL USE ONLY ENHANCED PRODUCTION VERSION

Compiled Wed 14−Jul−04 04:42 by esi

BOOT = bootflash:cat4000−i5s−mz.122_20_EWA_392,1

Configuration register = 0x2002

Peer Processor Information :

Standby Location = slot 2

Current Software state = STANDBY HOT

Uptime in current state = 2 days, 2 hours, 39 minutes

Image Version = Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000−I5S−M), Version 12.2(20)EWA(3

.92), CISCO INTERNAL USE ONLY ENHANCED PRODUCTION VERSION

Compiled Wed 14−Jul−04 0

BOOT = bootflash:cat4000−i5s−mz.122_20_EWA_392,1

Configuration register = 0x2002

show redundancy statesThis can be used to verify whether the redundant supervisor is in redundant

mode as expected.

Switch#show redundancy states

my state = 13 −ACTIVE

peer state = 8 −STANDBY HOT

Mode = Duplex

Unit = Primary

Unit ID = 2

Redundancy Mode (Operational) = Stateful Switchover

Redundancy Mode (Configured) = Stateful Switchover

Split Mode = Disabled

Manual Swact = Enabled

Communications = Up

client count = 21

client_notification_TMR = 240000 milliseconds

keep_alive TMR = 9000 milliseconds

keep_alive count = 0

keep_alive threshold = 18

RF debug mask = 0x0

•

Manual Switchover Commands

Manual switchover commands can be used to perform manual switchover from the active supervisor to the

redundant supervisor engine.

The redundancy force−switchover command launches the switchover only if the state of the redundant

supervisor engine is Standby Hot. If the state is not Standby Hot, the command does not process. Issue the

redundancy force−switchover command, rather than the reload command, to initiate a switchover. The

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco 4510R - Catalyst Switch Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco 4510R - Catalyst Switch