Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Arkusz Danych Pobierz pdf (Strona 75)

642-531

You can re-image the IDS module from the maintenance partition. After you re-image the IDS module, you

must initialize the IDS module using the setup command.

Recovering the Software Image

You can recover the software image for the IDS module if it becomes unusable. If you install a service pack on

an IDS module, for example, and it is unusable after it reboots, you must reimage the IDS module from the

maintenance partition.

Reference:Cisco Courseware 17-17 for the recovery of a Sensor Appliance

QUESTION 173

Which of the following statements regarding using IDS MC to upgrade a Cisco IDS Sensor is valid?

A. IDS MC can be used to update signature files only.

B. IDS MC can be used to update service packs only.

C. Update IDS MC prior to updating the Sensor.

D. There are no special requirements for IDS MC.

Answer: C

Explanation: Because ids mc push the upgrade to sensors.

Cisco Courseware 17-4

QUESTION 174

What will you advice the new Certkiller trainee technician to use inorder to maintain network

connectivity when upgrading IDS-4220 or IDS-4230-FE Sensor appliances from Cisco IDS v3.x?

A. Swap the console and monitoring interface connections

B. Swap the console and control interface connections

C. Swapping the interface connections is not necessary

D. Swap the control and monitoring interface connections

Answer: D

Cisco Courseware 7-16 Cable swap on the 4230 Sensor

Note: ...what about 4220?

For 4220, in this list there's only a memory upgrade stated.

QUESTION 175

Upon restoring a sensor's configuration to default, which application settings are not set to default?

Choose three.

A. IP address

B. netmask

C. allowed hosts

D. passwords

E. user accounts

F. time

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 122 123

Brak uwag

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Arkusz Danych Strona 75