
642-531
Explanation:
We must agree with the conclusion that this is nonsense, but E must be the correct answer since a hub a layer 2
device meaning that it doesn't do network segmenting. All devices connected to the hub wil receive the same
traffic.
QUESTION 47
Study the exhibit below carefully:
According to the exhibit all switches are connected through Fast Ethernet connections. Server Certkiller 3 is in
VLAN 8. The Catalyst 4000 is running Catalyst OS. Which of the following commands represents a valid
configuration step to permit IDS3 to monitor traffic sent to and from Server Certkiller 3?
A. 4000(config)# monitor session 1 source vlan 8 both
B. 4000(config)# monitor session 1 destination interface fastEthernet 3/24
C. 4000>(enable) set span 3/5 3/24 both create
D. 4000(config)# monitor session 1 source fastEthernet 3/5 destination fastEthernet 3/24 tx rx
E. 4000(config-if)# port monitor interface fastEthernet 3/5
F. This feature is not supported in this configuration
Answer: C
Cisco Courseware 5-18
QUESTION 48
Identify two basic steps in the configuration of VACLs for traffic capture on a Catalyst 6500 switch
running IOS. (Choose two.)
A. Configure match clauses using the capture option.
B. Map the VLAN access map to a VLAN.
C. Use commit to save the VACL configuration.
D. Assign ports to receive capture traffic.
E. Crate VACL using the set security acl command.
Answer: B, D
Explanation:
The tasks to capture traffic using VLAN Access Control Lists (VACLs) on a Catalyst 6500 switch running IOS
are as follows:
1) Configure ACLs to define interesting traffic.
2) Define a VLAN access map
3) Configure the match clause in the VLAN access map using ACLs
4) Configure the action clause in the VLAN access map using the capture option.
Komentarze do niniejszej Instrukcji