Cisco PIX 525 Dokumentacja Pobierz pdf (Strona 66)

100

101

5-6

Cisco Security Appliance Command Line Configuration Guide

OL-6721-01

Chapter 5 Adding and Managing Security Contexts

Changing the Security Context URL

To change between the system execution space and a context, or between contexts, see the following

commands:

• To change to a context, enter the following command:

hostname# changeto context

name

The prompt changes to the following:

hostname/

name

• To change to the system execution space, enter the following command:

hostname/admin# changeto system

The prompt changes to the following:

hostname#

Changing the Security Context URL

You cannot change the security context URL without reloading the configuration from the new URL.

The security appliance merges the new configuration with the current running configuration. Reentering

the same URL also merges the saved configuration with the running configuration. A merge adds any

new commands from the new configuration to the running configuration. If the configurations are the

same, no changes occur. If commands conflict or if commands affect the running of the context, then the

effect of the merge depends on the command. You might get errors, or you might have unexpected

results. If the running configuration is blank (for example, if the server was unavailable and the

configuration was never downloaded), then the new configuration is used. If you do not want to merge

the configurations, you can clear the running configuration, which disrupts any communications through

the context, and then reload the configuration from the new URL.

To change the URL for a context, perform the following steps:

Step 1 If you do not want to merge the configuration, change to the context and clear its configuration by

entering the following commands. If you want to perform a merge, skip to Step 2.

hostname# changeto context

name

hostname/

name

# configure terminal

hostname/

name

(config)# clear configure all

Step 2 If required, change to the system execution space by entering the following command:

hostname/

name

(config)# changeto system

Step 3 To enter the context configuration mode for the context you want to change, enter the following

command:

hostname(config)# context

name

Step 4 To enter the new URL, enter the following command:

hostname(config)# config-url

new_url

The system immediately loads the context so that it is running.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 603 604

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco PIX 525 Dokumentacja Strona 66

Komentarze do niniejszej Instrukcji