Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module Instrukcja Użytkownika Pobierz pdf (Strona 22)

White Paper

Now add the ports on each switch to the port channel that corresponds to the respective side of the VSL using the follow ing

commands:

VSS-sw1(config)#interface range

tenGigabitEthernet 5/4 - 5

VSS-sw1(config-if-range)#channel-group 1

mode on

VSS-sw1(config-if-range)#no shut

VSS-sw1(config-if-range)#^Z

VSS-sw1#

VSS-sw2(config)#interface range

tenGigabitEthernet 5/4 - 5

VSS-sw2(config-if-range)#channel-group 2

mode on

VSS-sw2(config-if-range)#no shut

VSS-sw2(config-if-range)#^Z

VSS-sw2

Note that only the local port channels and their associated members need to be configured on each switch. Because

the switches are still in standalone mode, you do not need to configure the peer-switch ports.

Step 3. Convert to virtual switch mode.

Convert both switches to virtual switch mode using the following exec command:

VSS-sw1#switch convert mode virtual

This command will convert all interface

names to naming convention “interface-type

switch-number/slot/port,” save the running

config to startup-config and reload the

switch.

Do you want to proceed? [yes/no]: yes

Converting interface names

Building configuration...

[OK]

Saving converted configurations to

bootflash …

[OK]

VSS-sw2#switch convert mode virtual

This command will convert all interface

names to naming convention “interface-type

switch-number/slot/port,” save the running

config to startup-config and reload the

switch.

Do you want to proceed? [yes/no]: yes

Converting interface names

Building configuration...

[OK]

Saving converted configurations to

bootflash…

[OK]

The following actions occur when you issue this command:

●

The running configuration of the individual switch is converted into a three-level virtual switch interface

notation. Two-level interface configurations (such as TenGigabitEthernet 5/4) are converted into three-level

interfaces (such as TenGigabitEthernet 1/5/4 in switch 1 and TenGigabitEthernet 2/5/4 in switch 2).

●

The startup configuration is updated with the three-number notation.

●

A copy of the original startup configuration converted to three-number notation is written to the multilayer

switch feature card (MSFC) bootflash of the respective switch. Both switches reload.

Note that the command switch convert mode virtual is not stored in the startup configuration because it is not a

configuration command. Instead, the following line is added to the startup configuration under the switch virtual

domain:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module Instrukcja Użytkownika Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco WS-X6708-10G-3CXL= - 10 Gigabit Ethernet Module