Cisco PRP-1= Dokumentacja Strona 2
- Strona / 88
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
2
OL-17436-01
Important Information
Important Information
This section contains information about the following hardware and software requirements:
• Router Information, page 2
• Cisco IOS XR Software Requirements, page 2
• Hardware Revision Requirements, page 3
Router Information
For hardware installation and maintenance information about the Cisco XR 12000 Series Router, refer
to the installation and configuration guide for your router. This includes information on card slot
locations and other general requirements.
Supported Platforms
The PRP is supported on all Cisco XR 12000 Series Router chassis and can be installed in any available
slot in any chassis; however PRP-3 is supported only on the Cisco XR 128xx and 124xx Series Router
chassis. Also, PRP-1 is only supported on the Cisco 12000 Series Router chassis running Cisco IOS
Software.
PRP Redundancy
When two PRPs are installed in a Cisco XR 12000 Series Router, one PRP is the active PRP and the
other is a backup, or standby, PRP. If the active PRP fails or is removed from the system, the standby
PRP detects the failure and initiates a switchover. During a switchover, the standby PRP assumes control
of the router, connects with the network interfaces, and activates the local network management interface
and system console.
Note If your system includes redundant PRPs, both PRPs should be of the same type (PRP-3 or PRP-2) and
have the same memory size. We strongly recommend that you avoid configuring your router using mixed
route processor cards.
Cisco IOS XR Software Requirements
For software configuration information, refer to the Cisco IOS XR getting started, configuration, and
command reference publications for the installed Cisco IOS XR software release. Refer to the
CiscoIOSR software release notes for additional information.
Note PRP-2 is compatible with Cisco IOS XR Software Release 3.2 or later releases, but PRP-3 is compatible
only with Cisco IOS XR Software Release 3.8.0 and later releases. PRP-1 is not supported with any of
the Cisco IOS XR Software Releases. PRP-1 is only supported on Cisco IOS Software Releases.
The show version and show hardware commands display the current hardware configuration of the
router, including the system software version that is currently loaded and running.
- Performance Route Processor 1
- Important Information 2
- Product Overview 3
- PRP Functions 4
- PRP Components 4
- Cisco IOS Software Storage 6
- Cisco IOS XR Software Storage 6
- PRP-3 ROMMON Changes 7
- PRP Hardware Components 10
- OL-17436-01 12
- Product Overview 12
- PRP-3 Compact Flash 14
- PRP LEDs 15
- Soft Reset Switch 16
- Flash Disk Slots 16
- Asynchronous Serial Ports 16
- Preparing for Installation 17
- Safety Guidelines 18
- Removing and Installing a PRP 19
- Removing a PRP 20
- Step 2 Turn off system power 21
- Installing a PRP 22
- Checking the Installation 23
- PROCESSOR 1 (PRP-1) 24
- Single PRP-3 Scenario 25
- Dual PRP-3 Scenario 26
- Table 9 Dual PRP-3 Scenario 27
- Checking the Installation 28
- Rommon>) 28
- Verifying Interface Status 30
- Upgrading to the PRP 31
- Turboboot Approach 39
- Pre-Staging Approach 40
- 8 7 6 5 4 3 2 1 42
- Table 13 Console Port Pinout 47
- SUMMARY STEPS 48
- DETAILED STEPS 49
- Username: 52
- CLI Prompt 53
- RP/0/RP0/CPU0:router# 54
- Prerequisites 56
- Examples 58
- Related Documents 58
- Boot Field Settings 61
- Removing a Flash Disk 68
- Installing a Flash Disk 69
- Booting from a Flash Disk 70
- THIS SIDE TO FACEPLATE 73
- HD-PRP2-40G 73
- 800-24060-01 REV__ 73
- Upgrading PRP Memory 78
- Removing a DIMM 81
- Installing a DIMM 82
- FCC Class A Compliance 84
- CISPR 22 85
- Europe (EU) 85
- Class A Notice for Hungary 85
- VCCI Class A Notice for Japan 86
- Class A Notice for Korea 86
- , Cisco Stackpower 87
Powiązane produkty i podręczniki dla Networking Cisco PRP-1=
Networking Cisco 2503 Podręcznik Użytkownika
(42 strony)
(42 strony)
Networking Cisco 3620 Instrukcja Użytkownika
(8 strony)
(8 strony)
Networking Cisco E2500 Instrukcja Użytkownika
(27 strony)
(27 strony)
Networking Cisco CISCO2821 Dokumentacja
(31 strony)
(31 strony)
Networking Cisco 7505 Instrukcja Użytkownika
(14 strony)
(14 strony)
Networking Cisco uBR7225VXR Dokumentacja
(20 strony)
(20 strony)
Networking Cisco PA-5EFL= Dokumentacja
(40 strony)
(40 strony)
(56 strony)
Networking Cisco 7609 Dokumentacja
(572 strony)
(572 strony)
Kenwood MFJ-286 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Mikrofony Kenwood MFJ-286.
Dostarczamy 1 pdf podręczników Kenwood MFJ-286 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentarze do niniejszej Instrukcji