Cisco MC3810-V - Concentrator - External Przewodnik Instalacji Pobierz pdf (Strona 28)

Perform Initial Conﬁguration (continued)

Note: If you are not going to use a voice port, shut it down to conserve bandwidth.

To conﬁgure voice-port tuning options, see the section “Conﬁguring Voice-Port Tuning Options” in the

“Conﬁguring Voice Ports” chapter of the Cisco MC3810 Multiservice Access Concentrators Software

Conﬁguration Guide.

To conﬁgure dial peers, see the applicable voice service conﬁguration section in the Cisco MC3810 Multiservice

Access Concentrators Software Conﬁguration Guide.

Step Command Purpose

router(config)# voice-port

slot/port

Enter voice-port conﬁguration mode, and specify the voice port

you want to conﬁgureby enteringthe logicalslot numberand port

number (see table on page 23). The following commands affect

only the voice port you specify here.

router(config-voiceport)#

dial-type {pulse | dtmf}

Change the transmit dial type if necessary (FXO and E&M ports

only). The default is dtmf.

Only FXO and FXS ports transmit dial pulses.

router(config-voiceport)#

compand-type {u-law | a-law}

Change the companding if necessary. The default is u-law (the

North American mu-law ITU-T PCM encoding standard). Specify

a-law to use the European a-law ITU-T PCM encoding standard.

router(config-voiceport)#

no shutdown

Activate the voice port. You should activate only those voice ports

you are planning to use.

Exit from voice-port conﬁguration mode and repeat Steps 6 through 9 for the remaining digital voice ports.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Brak uwag

Cisco MC3810-V - Concentrator - External Przewodnik Instalacji Strona 28