Cisco BEFVP41 Podręcznik Użytkownika Strona 26
- Strona / 83
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
20
Chapter 6: Using The Router’s Web-based Utility
The Setup tab
EtherFast Cable/DSL VPN Router with 4-Port 10/100 Switch
Primary DNS and Secondary DNS. Your ISP will provide you with at least one DNS (Domain Name System)
Server IP Address.
Host Name/Domain Name. Enter a Host Name and Domain Name if required by your ISP.
MTU. The MTU option specifies the largest packet size permitted for network transmission. Select Manual if
you do not want the Router to regulate this packet size (otherwise, leave it set at Automatic) and enter the
value desired. You should leave this value in the 1200 to 1500 range. Most DSL users should use the default
of 1400.
Connection Type: PPPoE
Some DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to establish Internet connections for
end-users. If you use a DSL line, check with your ISP to see if they use PPPoE. If they do, you will have to
enable it.
User Name and Password. Enter the User Name and Password provided by your ISP.
Service Name. If provided by your ISP, enter the Service Name.
Connect on Demand and Max Idle Time. You can configure the Router to cut your connection with your ISP
after a specified period of time (Max Idle Time). If you have been disconnected due to inactivity, Connect on
Demand enables the Router to automatically re-establish your connection as soon as you attempt to access
the Internet again. If you wish to activate Connect on Demand, click the radio button. If you want your Internet
connection to remain on at all times, enter 0 in the Max Idle Time field. Otherwise, enter the number of
minutes you want to have elapsed before your Internet access disconnects.
Keep Alive Option and Redial Period. This option keeps your PPPoE-enabled Internet access connected
indefinitely, even when it sits idle. To use this option, click the radio button next to Keep Alive. The default
Redial Period is 30 seconds.
Host Name/Domain Name. Enter a Host Name and Domain Name if required by your ISP.
MTU. The MTU option specifies the largest packet size permitted for network transmission. Select Manual if
you do not want the Router to regulate this packet size (otherwise, leave it set at Automatic) and enter the
value desired. You should leave this value in the 1200 to 1500 range. Most DSL users should use the default
of 1400.
When you are finished, click the Save Settings button. Then click the Status tab, and click the Connect
button to start the connection.
Figure 6-6: PPPoE Connection type
- Cable/DSL VPN Router 1
- How to Use this Guide 2
- Copyright and Trademarks 2
- Table of Contents 3
- List of Figures 5
- Chapter 1: Introduction 7
- What’s in this Guide? 8
- Why do I need a VPN? 10
- VPN Router to VPN Router 12
- The Back Panel 13
- The Front Panel 14
- Overview 15
- Connection Instructions 16
- Static IP 19
- Heart Beat Signal 21
- Navigating the Utility 22
- Access Restrictions 23
- Applications & Gaming 23
- Administration 23
- Accessing the Utility 24
- The Setup tab 24
- Basic Setup 25
- Connection Type: PPPoE 26
- Connection Type: PPTP 28
- Network Setup 30
- Router IP 30
- MAC Address Clone 31
- Advanced Routing 32
- The Security tab 34
- VPN Tunnel 35
- Advanced VPN Tunnel Setup 38
- The Access Restrictions tab 39
- Port Range Forwarding 40
- Port Triggering 41
- UPnP Forwarding 42
- The Administration tab 45
- Diagnostics 47
- Factory Defaults 48
- Firmware Upgrade 48
- The Status tab 49
- Local Network 50
- Appendix A: Troubleshooting 51
- Common Problems and Solutions 52
- For Netscape 4.7 or higher: 57
- Frequently Asked Questions 60
- Ethernet Adapter 66
- Appendix D: Windows Help 68
- Appendix G: SNMP Functions 72
- Appendix H: Glossary 73
- Appendix I: Specifications 77
Powiązane produkty i podręczniki dla Networking Cisco BEFVP41
Networking Cisco NAS200 Instrukcja Użytkownika
(38 strony)
(38 strony)
Networking Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Arkusz Danych
(168 strony)
(168 strony)
Networking Cisco WRT54GP2 Podręcznik Użytkownika
(94 strony)
(94 strony)
Networking Cisco Spam Podręcznik Użytkownika
(20 strony)
(20 strony)
Networking Cisco EPC2607 Instrukcja Użytkownika
(28 strony)
(28 strony)
Networking Cisco 12810 Dokumentacja
(30 strony)
(30 strony)
Networking Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router Podręcznik Użytkownika
(180 strony)
(180 strony)
Networking Cisco EA-Series Podręcznik Użytkownika
(144 strony)
(144 strony)
Networking Cisco 888E Instrukcja Użytkownika
(18 strony)
(18 strony)
Networking Cisco DPC2203 Instrukcje Operacyjne
(98 strony)
(98 strony)
Networking Cisco 12016 Dokumentacja
(36 strony)
(36 strony)
Kenwood MFJ-286 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Mikrofony Kenwood MFJ-286.
Dostarczamy 1 pdf podręczników Kenwood MFJ-286 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentarze do niniejszej Instrukcji