Cisco 2504 - 2504 Router Instrukcja Użytkownika Pobierz pdf (Strona 6)

6 Replacing the Boot ROMs in the Cisco 2500 Series and AccessPro PC Card Routers

Removing the Cover or AccessPro PC Card

Step 5 Grasp the posts on the management card tray and gently pull it out of the chassis. (See

Figure 5.)

Figure 5 Removing the Management Card Tray (Cisco 2517 Shown)

Step 6

Proceed to the section “Replacing the Boot ROMs—All Models” on page 7.

Removing the AccessPro PC Card

To remove the AccessPro PC card, follow these steps:

Step 1 Turn the PC power OFF.

Step 2 Disconnect all cables from the AccessPro PC card.

Step 3 Attach an ESD-preventive wrist strap and make certain the PC chassis is properly

grounded.

Step 4 Remove the cover from your PC, following the instructions provided by the PC

manufacturer.

Step 5 Locate the AccessPro PC card in its Industry Standard Architecture (ISA)-bus slot. Remove

the screw that secures the card bracket to the PC chassis. If a daughter card is installed,

remove the screw that secures the daughter card bracket to the PC chassis.

Step 6 Place the AccessPro PC card on a nonconductive surface.

Step 7 Proceed with the next section, “Replacing the Boot ROMs—All Models.”

H4533

Posts

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Brak uwag

Cisco 2504 - 2504 Router Instrukcja Użytkownika Strona 6