Cisco 2504 - 2504 Router Instrukcja Użytkownika Pobierz pdf (Strona 21)

Replacing the Boot ROMs in the Cisco 2500 Series and AccessPro PC Card Routers 21

Replacing the Cover or AccessPro PC Card

Caution To ﬁt the two sections together it may be necessary to work them together at one end and

then the other until the two sections ﬁt together snugly. Make sure you do not bend the edges of the

chassis because damage may occur.

Step 3 When the two sections ﬁt together snugly, turn the chassis so that the bottom is facing up,

with the front panel toward you.

Step 4 Replace the cover screw and tighten it to no more than 8 or 9 inch-pounds of torque.

Step 5 Reinstall the chassis on the wall, in the rack, on a desk, or on a table.

Step 6 Reconnect all cables and turn the power ON.

Replacing the Front Cover—Cisco 2517–2519 Router/Hubs

The Cisco 2517–2519 chassis are different from the other Cisco 2500 series models. To replace the

front cover on the Cisco 2517–2519 router/hubs, follow these steps:

Step 1 Gently push the management card tray along the card guides into the management card tray.

(See Figure 5.)

Step 2 Replace the four screws that secure the management card tray to the chassis. (See Figure 4.)

Step 3 Replace the two captive screws that secure the plastic cover to the front of the chassis. (See

Figure 3.)

Step 4 Reconnect all cables and turn the power ON.

Replacing the AccessPro PC Card

To replace the AccessPro PC card, follow these steps:

Step 1 Insert the AccessPro PC card into its ISA slot on the PC motherboard. Carefully align the

edge connector on the ISA slot, and use a rocking motion to seat the card in the proper

position. Secure the card in the ISA slot with the bracket screw.

Step 2 Replace the cover of the PC, following the directions provided by the PC manufacturer.

Step 3 Reconnect all cables and turn the power ON.

1 2 ... 16 17 18 19 20 21 22

Brak uwag

Cisco 2504 - 2504 Router Instrukcja Użytkownika Strona 21