Cisco GoQAM Informacje Techniczne Pobierz pdf (Strona 35)

100

101

CLI Login and Logout

4025561 Rev

To Log Out

To log out of the CLI and exit the session, type logout, and then press Enter.

Note: The CLI recognizes the logout command at any command prompt, regardless

of the current command mode.

Important:

 For Telnet operation, the computer you are using must have a network

connection through which it can reach the ICIM2 using its IP address.

 No more than four Telnet sessions are allowed at one time.

 If IPsec is enabled on the ICIM2, it must also be enabled on the remote CLI user's

computer.

CAUTION:

Always use the Logout command to close a serial port or Telnet CLI session.

Closing a serial port session without issuing the Logout command leaves the

session open for a possible future connection. This may allow unauthorized

access by a new user if the previous user had a higher authorization privilege

level.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 307 308

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco GoQAM Informacje Techniczne Strona 35

Komentarze do niniejszej Instrukcji