Cisco MC3810 Przewodnik Instalacji Pobierz pdf (Strona 21)

Configuring E&M Voice Ports

Configuring Voice over IP for Cisco MC3810 Series Concentrators 21

Conﬁguring E&M Voice Ports

The default E&M voice-port parameters will probably not be sufﬁcient to enable voice transmission

over your network. Conﬁguration parameters depend on the PBX to which the voice port is

connected.

Note E&M voice-port values must match those of the PBX to which the voice port is connected.

Refer to the documentation that came with your PBX to determine the E&M voice-port

conﬁguration values.

Task List

To conﬁgure E&M voice ports, perform the following tasks:

1 Conﬁgure the applicable parameters for the voice port.

2 Verify the conﬁguration.

3 Troubleshoot and correct any conﬁguration errors.

Conﬁguration Procedure

To conﬁgure E&M voice ports, enter the following commands beginning in global conﬁguration

mode. Commands apply to both analog and digital voice ports unless otherwise indicated.

router(config-voiceport)# disconnect-ack

(FXS only) Conﬁgure the voice port to return an

acknowledgment upon receipt of a disconnect signal.

router(config-voiceport)# ring cadence

{[pattern01 | pattern02 | pattern03 | pattern04 |

pattern05 | pattern06 | pattern07 | pattern08 |

pattern09 | pattern10 | pattern11 | pattern12 ]

[define

pulse-interval

]}

(FXS only) Specify the on and off times for the ringing pulses.

See the command reference section for details on the ring

cadence options.

router(config-voiceport)#exit

Exit from voice-port conﬁguration mode.

Step Command Purpose

router(config)# voice-port

slot/port

Identify the voice port you want to conﬁgure and enter voice-port

conﬁguration mode.

Step Command Purpose

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 77 78

Brak uwag

Cisco MC3810 Przewodnik Instalacji Strona 21