Cisco Cisco Access Registrar 4.2 Dokumentacja Pobierz pdf (Strona 118)

100

101

4-20

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 4 Configuring Controller SettingsWireless Device Access

Configuring SNMP

Step 4 Enter config radius acct enable to enable accounting. Enter config radius acct disable to disable

accounting. Accounting is disabled by default.

Step 5 Enter config radius auth ip-address to configure a RADIUS server for authentication.

Step 6 Enter config radius auth port to specify the UDP port for authentication.

Step 7 Enter config radius auth secret to configure the shared secret.

Step 8 Enter config radius auth enable to enable authentication. Enter config radius acct disable to disable

authentication. Authentication is disabled by default.

Step 9 Use the show radius acct statistics, show radius auth statistics, and show radius summary

commands to verify that the RADIUS settings are correctly configured.

Configuring SNMP

Cisco recommends that you use the GUI to configure SNMP settings on the controller. To use the CLI,

follow these steps:

Step 1 Enter config snmp community create name to create an SNMP community name.

Step 2 Enter config snmp community delete name to delete an SNMP community name.

Step 3 Enter config snmp community accessmode ro name to configure an SNMP community name with

read-only privileges. Enter config snmp community accessmode rw name to configure an SNMP

community name with read-write privileges.

Step 4 Enter config snmp community ipaddr ip-address ip-mask name to configure an IP address and subnet

mask for an SNMP community.

Note This command behaves like an SNMP access list. It specifies the IP address from which the

device accepts SNMP packets with the associated community. The requesting entity’s IP address

is ANDed with the subnet mask before being compared to the IP address. If the subnet mask is

set to 0.0.0.0, an IP address of 0.0.0.0 matches to all IP addresses. The default value is 0.0.0.0.

Note The controller can use only one IP address range to manage an SNMP community.

Step 5 Enter config snmp community mode enable to enable a community name. Enter config snmp

community mode disable to disable a community name.

Step 6 Enter config snmp trapreceiver create name ip-address to configure a destination for a trap.

Step 7 Enter config snmp trapreceiver delete name to delete a trap.

Step 8 Enter config snmp trapreceiver ipaddr old-ip-address name new-ip-address to change the destination

for a trap.

Step 9 Enter config snmp trapreceiver mode enable to enable traps. Enter config snmp trapreceiver mode

disable to disable traps.

Step 10 Enter config snmp syscontact syscontact-name to configure the name of the SNMP contact. Enter up to

31 alphanumeric characters for the contact name.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 635 636

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco Cisco Access Registrar 4.2 Dokumentacja Strona 118

Komentarze do niniejszej Instrukcji