Cisco RSP7000 Instrukcja Użytkownika

PA-E3 and PA-2E3 Serial Port Adapter 1PA-E3 and PA-2E3 Serial Port AdapterDescriptionThe PA-E3 and PA-2E3 serial port adapters are available on Cisco

10 Release 11.1 CACommand Referenceinvert dataTo invert the data stream, use the invert data interface configuration command. This command applies onl

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 11loopbackTo loop the serial interface on a PA-E3 port adapter, use the loopback interface conf

12 Release 11.1 CACommand Referencenational bitTo set the E3 national bit in the G.751 frame used by the PA-E3 port adapter, use the national bit inte

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 13scrambleTo enable scrambling of the payload on the PA-E3 port adapter, use the scramble inter

14 Release 11.1 CACommand Referenceshow controllers serialUse the show controllers serial privileged EXEC command to display information that is speci

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 15mxt_ds=0x608BA654, rx ring entries=128, tx ring entries=256rxring=0x4B01F480, rxr shadow=0x60

16 Release 11.1 CACommand Referenceshow diagTo display hardware information for an interface, use the show diag privileged EXEC command on Cisco 7500

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 17show interfaces serialTo display information about a serial interface, use the show interface

18 Release 11.1 CACommand ReferenceTable 2 describes significant fields shown in the display.Table 2 Show Interfaces Serial Field Descriptions Field D

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 195 minute input rate5 minute output rateAverage number of bits and packets transmitted per sec

2 Release 11.1 CAConfiguration TasksConfiguration TasksPerform the tasks in the following sections to configure the PA-E3 (all tasks are optional exce

20 Release 11.1 CASupported MIBSupported MIBThe PA-E3 port adapter supports a subset of RFC 1407 MIB. We support DS3 Near End Group including—DS3/E3 C

Configuration Tasks PA-E3 and PA-2E3 Serial Port Adapter 3Troubleshoot the PA-E3 Port AdapterTo set the following loopbacks to troubleshoot the PA-E3

4 Release 11.1 CAConfiguration ExampleConfiguration ExampleThe following example shows a typical configuration for serial interface 1/0/0 on a PA-E3 s

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 5clock source (interface)To control which clock a G.703 E1 interface, an E1-G.703/G.704 serial

6 Release 11.1 CACommand Referencedsu bandwidthTo specify the maximum allowable bandwidth used by the PA-E3 port adapter, use the dsu bandwidth interf

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 7dsu modeTo specify the interoperability mode used by the PA-E3 port adapter, use the dsu mode

8 Release 11.1 CACommand ReferenceframingTo specify E3 line framing used by the PA-E3 port adapter, use the framing interface configuration command. T

Command Reference PA-E3 and PA-2E3 Serial Port Adapter 9international bitTo set the E3 international bit in the G.751 frame used by the PA-E3 port ada