Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Przewodnik Instalacji Pobierz pdf (Strona 124)

Appendix D Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

D-8

Catalyst 3550 Multilayer Switch Hardware Installation Guide

78-11358-06

interface FastEthernet0/1

interface FastEthernet0/2

interface FastEthernet0/3

...<output abbreviated>

interface GigabitEthernet0/10

end

Step 10 These choices appear:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to use the configuration the next time the switch reboots, save it in

NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

After you complete the setup program, the switch can run the default

configuration that you created. If you want to change this configuration or want

to perform other management tasks, use one of these tools:

• CLI

• CMS from your browser

To use the CLI, enter commands at the Switch> prompt through the console port

or through the network by using Telnet. For configuration information, refer to the

switch software configuration guide or the switch command reference.

To use CMS, refer to the software configuration guide.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 175 176

Brak uwag

Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Przewodnik Instalacji Strona 124