Cisco Wide Area Virtualization Engine 274 Instrukcja Naprawy Pobierz pdf (Strona 567)

100

101

1-13

Cisco Wide Area Application Services Configuration Guide

OL-26579-01

Chapter 1 Configuring SNMP Monitoring

Preparing for SNMP Monitoring

Before you configure your WAAS network for SNMP monitoring, complete the following preparation

tasks:

• Set up the SNMP host (management station) that the WAAS devices will use to send SNMP traps.

• Determine if all your WAAS devices will be sending traps to the same host, or to different hosts.

Write down the IP address or hostname of each SNMP host.

• Obtain the community string used to access the SNMP agents.

• Determine if you want to create SNMP groups so you can restrict views by group.

• Determine what additional SNMP traps you need.

• Clock synchronization between the devices in a WAAS network is important. On each WAAS

device, be sure to set up a Network Time Protocol (NTP) server to keep the clocks synchronized.

Enabling SNMP Traps

To enable a WAAS device to send SNMP traps, follow these steps:

Step 1 From the WAAS Central Manager menu, choose Devices > device-name (or Device Groups >

device-group-name).

Step 2 Choose Configure > Monitoring > SNMP > General Settings. The SNMP General Settings window

appears. (See Figure 1-2.) Table 1-3 describes the fields in this window.

1 2 ... 562 563 564 565 566 567 568 569 570 571 572 ... 593 594

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco Wide Area Virtualization Engine 274 Instrukcja Naprawy Strona 567

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco Wide Area Virtualization Engine 274