Cisco VPN 3000 Instrukcja Użytkownika Pobierz pdf (Strona 2)

Cisco VPN 3000 Series Concentrators Interoperability Profile

Configuring the Gateway A VPN Concentrator

The IKE Phase I parameters used in Scenario 1 are:

• Main mode

• Triple DES

• SHA-1

• MODP group 2 (1024 bits)

• pre-shared secret of hr5xb8416aa9r6

• SA lifetime of 28800 seconds (8 hours) with no kbytes rekeying

The IKE Phase 2 parameters used in Scenario 1 are:

• Triple DES

• SHA-1

• MODP group 2 (1024 bits)

• Perfect forward secrecy for rekeying

• SA lifetime of 3600 seconds (one hour) with no kbytes rekeying

Selectors for all IP protocols, all ports, between 10.5.6.0/24 and 172.23.9.0/24, using IPv4 subnets.

Configuring the Gateway A VPN Concentrator

See the VPN 3000 Series Concentrator Getting Started guide, Chapter 2, for instructions on installing

and powering up the VPN Concentrator. Then you are ready to configure the VPN Concentrator,

accepting default values when possible.

Using the Console to Configure the Private Interface

You must use the console for the first configuration steps—setting the system time and date, and

configuring the private Ethernet interface (to the internal LAN), as described in the following steps. Then

you can use the HTML-based VPN Concentrator Manager from a browser to complete configuration.

Step 1 You started the terminal emulator window on the console in the “Powering Up” section of the VPN

3000 Series Getting Started guide; if not, start it now and press

Enter on the console keyboard until you

see the login prompt. (You may see a password prompt and other messages as you press

Enter. Ignore

them and stop at the login prompt.)

Step 2 At the cursor, enter the default login name: admin. At the password prompt, enter the default password:

admin.

Password: admin

1 2 3 4 5 6 7 ... 24 25

Brak uwag

Cisco VPN 3000 Instrukcja Użytkownika Strona 2