Cisco Octal-Port DMT ATU-C Line Card Przewodnik Instalacji Strona 8
- Strona / 24
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
8
Cisco 6160 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures
OL-0992-01
Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures
Note Before installing and cabling the equipment, be aware of standard safety practices and the hazards
involved in working with electrical circuitry to prevent accidents. See the “General Safety
Precautions” section on page 3 for all cautions and warnings that are necessary to ensure a safe and
hazard-free installation.
Conversion Checklist
When you convert your system from 4xflexis to 8xDMTs, be sure that you follow the conversion
procedures in the proper sequence. Table 2 is a checklist of the conversion steps in the order in which
they should occur. Detailed conversion instructions are located in the sections following Table 2.
Caution Proper ESD protection is required whenever you handle Cisco equipment. Installation and
maintenance personnel should be properly grounded using ground straps to eliminate the risk of ESD
damage to the equipment. Cards are subject to ESD damage whenever they are removed from
the chassis.
Conversion Procedures
The following sections detail the procedures for converting your Cisco 6160 system from 4xflexis
to 8xDMTs.
Upgrade IOS
You need to upgrade the IOS software to Release 12.1(6)DA. Refer to the IOS configuration guide for
upgrade procedures.
Table 2 Conversion Procedure Checklist
Check Conversion Step
1. Upgrade IOS.
2. Remove the power.
3. Measure the rack space and prepare the rack.
4. Stabilize the rack.
5. Install the POTS splitter, as necessary.
6. Verify the Cisco 6160 cabling.
7. Remove the 4xflexis.
8. Install the 8xDMTs.
9. Verify the correct fuses.
10. Apply power to the system.
11. Provision the 8xDMTs.
12. Verify CPE
1
compatibility.
1. CPE = customer premises equipment
- Contents 1
- Conversion Prerequisites 1
- Configuration Requirements 2
- Part and Tool Requirements 2
- General Safety Precautions 3
- Conversion Procedures 7
- Conversion Checklist 8
- Remove the Power 9
- Install the POTS Splitter 10
- Verify the Cisco 6160 Cabling 11
- Remove the 4xflexis 11
- Install the 8xDMTs 11
- OL-0992-01 12
- Verify Correct Fuses 13
- Apply Power 13
- Verify CPE Compatibility 14
- Related Documentation 20
- Obtaining Documentation 21
- Cisco.com 22
- Technical Assistance Center 22
- Contacting TAC by Telephone 23
Powiązane produkty i podręczniki dla Networking Cisco Octal-Port DMT ATU-C Line Card
(196 strony)
(6 strony)
(38 strony)Kenwood MFJ-286 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Mikrofony Kenwood MFJ-286.
Dostarczamy 1 pdf podręczników Kenwood MFJ-286 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentarze do niniejszej Instrukcji