Cisco ISE - Line Card ISE Instrukcja Użytkownika Pobierz pdf (Strona 37)

Cisco IOSSoftware Configurationforthe Cisco12000Series One-PortChannelized OC-12/STM-4(DS1/E1)ISE Line

Configuring the Serial Interfaces

Cisco IOS Release 12.0(27)S1

Follow these steps to configure the 1-Port CHOC-12 ISE line card interface, beginning in privileged

EXEC mode:

Step 1 Enter the configure terminal EXEC command to enter global configuration mode as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Step 2 Specify the 1-Port CHOC-12 ISE line card interface by entering the interface serial global

configuration command in the appropriate format (see Table 10).

Router(config)# interface serial 2/0.1/2/4/1:15 (for SDH with au-4 AUG mapping)

Router(config-if)#

Router(config)# interface serial 3/0.3/4/1:15 (for SDH with au-3 AUG mapping)

Router(config-if)#

Router(config)# interface serial 4/0.3/5/1:15 (for SONET and vt-15 mode)

Router(config-if)#

Router(config)# interface serial 4/0.3/26:15 (for SONET and ct3 mode)

Router(config-if)#

The prompt changes to interface configuration mode.

Step 3 Use the ip address interface configuration command to specify an interface by an IP address and

subnet mask:

Router(config-if)# ip address 10.0.0.1 255.255.255.0

Router(config-if)#

Step 4 Add any additional configuration commands required to enable routing protocols and set the interface

characteristics.

Step 5 To change the shutdown state to up and enable the interface, use the no shutdown interface command:

Router(config-if)# no shutdown

Router(config-if)#

Step 6 Repeat Step 2 through Step 5 to configure additional interfaces, as required.

Table 10 Serial Interface Command Format

Framing Configuration Command Syntax

SDH; AU-4 AUG mapping interface serial slot/port.au-4-number/tug-3-number/

tug-2-number/e1-number:channel-group-number

SDH; AU-3 AUG mapping interface serial slot/port.au-3-number/tug-2-number/t1-number:

channel-group-number

SONET; CT3 mode interface serial slot/port.sts1-number/t1-number:

channel-group-number

SONET; VT1.5 mode interface serial slot/port.sts1-number/vtg-number/t1-number:

channel-group-number

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

Brak uwag

Cisco ISE - Line Card ISE Instrukcja Użytkownika Strona 37