Cisco IAD2431-1T1E1 Przewodnik Instalacji Pobierz pdf (Strona 11)

Figure 7 Telco 19-Inch Rack-Mounting with Rear Panel Forward

Step 2 Install the chassis in the rack.

Wall-Mounting the Chassis

The following warning applies only when the unit is wall-mounted:

Warning

This unit is intended to be mounted on a wall. Please read the wall mounting instructions carefully before

beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a

hazardous situation to people and damage to the system. Statement 248

Caution You can wall-mount the unit with either the right or left side facing up; however, the front and rear panels must be

vertical.

To wall-mount the chassis, follow this procedure:

Step 1 Attach the short leg of one bracket to the chassis, as shown in Figure 8, using two 6-32 x 1/4 slotted hex screws

(provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the washer must fit into the

bracket slot, facing the chassis.

Caution Be sure to use the correct screws and plastic washers for this mounting option. (See Table 1 on page 9.)

Figure 8 Attaching the Brackets for Wall-Mounting

Step 2 Attach the second bracket to the opposite side of the chassis.

Step 3 Attach the router to the wall using the brackets previously attached and attachment hardware that you provide as

follows:

• You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds the unit in place

for easy installation of the attachment screws.

88842

88843

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Brak uwag

Cisco IAD2431-1T1E1 Przewodnik Instalacji Strona 11