Cisco 7301 Informacje Techniczne Pobierz pdf (Strona 10)

Step 1 Align the cable-management bracket (1) to the rack-mount bracket on the left side of the Cisco 7301 router.

Step 2 Using a Phillips screwdriver and the

M4 x 20-mm screw (2), thread and tighten the screw to the cable-management

bracket.

Go to the “Four-Post Rack Installation” section on page 10 or the “Two-Post Rack Installation” section on page 11.

Four-Post Rack Installation

Figure 7 Installing the Cisco 7301 Router in a Four-Post Rack

Note Inner clearance (the width between the inner sides of the two posts or rails) must be at least 17.3 inches (43.9 cm) The

height of the chassis is 1.73 inches (4.39 cm). Airflow through the chassis is from front to back.

Step 1 Make sure that the port adapter latch is in the locked position and the screw is tightened.

Step 2 Make sure the rack brakes are locked or the rack (1) is stabilized.

Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden

twists or moves.

Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the

rack.

Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the

rack or mounting strip.

Step 6 For each bracket, insert and tighten two 12-24 x 0.5-inch screws (3) to the rack.

1 Four-post rack 3 Four 12-24 x 0.5-inch screws

2 Screw hole for cable-management bracket

ALARM

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/2

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/0

RJ45 EN

LINK

TX RX

GBIC

GIGABIT ETHERNET 0/1

CISCO 7301

SLOT 1

CONSOLEAUX

COMPACT

FLASH

STATUS

100-240V, 2A, 50/60 Hz

24V

9A, 48 - 60V

ENABLED

RX CELLS

RX CARRIER

RX ALARM

ATM

80908

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco 7301 Informacje Techniczne Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco 7301