Cisco 7000 and 7507 Chassis MAS-7507 Przewodnik Instalacji Pobierz pdf (Strona 5)

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 5

Rack-Mount Kit Overview

In Telco-type installations, you can install the chassis so that the ends of the chassis are

approximately centered on two posts. Figure 3 shows a typical center-mount installation.

Caution To maintain a safe center of gravity in Telco-type installations (shown in Figure 3), the

front and rear of the chassis are approximately centered on the mounting posts.

Figure 3 Typical Center-Mount Installation

In a 2-post, 4-post, or Telco-type installation, you can ﬂush-mount the chassis so that the end of the

chassis is ﬂush with the rack posts. (When mounting the non-interface processor end, the front is

actually recessed 1 inch into the rack to protect the plastic front bezel.) Multiple-chassis rack kits

can be stacked in a rack with little or no clearance between the brackets. You can remove the four

chassis feet after mounting the chassis in the rack.

H2296

1 2 3 4 5 6 7 8 9 10 ... 37 38

Brak uwag

Cisco 7000 and 7507 Chassis MAS-7507 Przewodnik Instalacji Strona 5