Cisco 2514 - Router - EN Instrukcja Użytkownika Pobierz pdf (Strona 10)

CONFIGURATION OF PCS AND ROUTERS - PAGE 10

IOS Configuration of the Cisco Routers

The following instructions set the default configuration for the Cisco routers.

New router

If you have a new Cisco Router, and access the router for the first time, the router enters the

initial configuration (“setup”) mode, where IOS asks to type a few configuration settings.

These configurations do not require knowledge of IOS commands. See the Cisco website or

the manual of the router for additional information. If you perform the initial configuration

dialogue, set the following configurations (here shown for Router1):

• Set the hostname to Router1.

• Set the required passwords (enable secret, enable password, virtual terminal

password). We suggest selecting all passwords to be identical. Make sure you write

down the password.

• When asked about configuring a protocol, answer “no” to all questions, except to the

question to configure IP.

• Eventually, IOS display a list of available interfaces. There should be 2 Ethernet

interfaces (Ethernet0 and Ethernet1, Ethernet0/0 and Ethernet0/1, or FastEthernet0/0

and FastEthernet0/1), and two serial WAN interfaces (Serial0 and Serial1, Serial1/0 and

Serial1/1).

Only configure the IP addresses of the two Ethernet interfaces. Do not configure the

other interfaces. Set the IP addresses and subnet masks, as shown in the table below.

Select the default for other configuration decisions.

Cisco

Router

Interface Ethernet0

or Ethernet0/0

or FastEthernet0/0

Interface Ethernet1

or Ethernet0/1

or FastEthernet0/1

Router1

IP address 10.0.1.1

Netmask 255.255.255.0

IP address 10.0.2.1

Netmask 255.255.255.0

Router2

IP address 10.0.1.2

Netmask 255.255.255.0

IP address 10.0.2.2

Netmask 255.255.255.0

Router3

IP address 10.0.1.3

Netmask 255.255.255.0

IP address 10.0.2.3

Netmask 255.255.255.0

Router4

IP address 10.0.1.4

Netmask 255.255.255.0

IP address 10.0.2.4

Netmask 255.255.255.0

•

Continue with the instructions for used routers.

1 2 ... 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag

Cisco 2514 - Router - EN Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cisco 2514 - Router - EN