Cisco 11503 - CSS Content Services Switch Dokumentacja Pobierz pdf (Strona 148)

Chapter 6 Configuring the Internet Protocol

IP Configuration Quick Start

6-2

Cisco Content Services Switch Routing and Bridging Configuration Guide

OL-8241-02

IP Configuration Quick Start

Table 6-1 provides a quick overview of the steps required to setup the IP

configuration for the CSS. Each step includes the CLI command required to

complete the task. For a complete description of each feature and all the options

associated with the CLI command, see the sections following Table 6-1.

Table 6-1 IP Configuration Quick Start

Task and Command Example

1. Configure an IP route for the CSS. You can configure a static route, default

route, a blackhole route, or a firewall route. For example, to configure a

static IP route, enter:

(config)# ip route 192.168.0.0 /16 192.167.1.1

2. (Optional) If you do not want the CSS to start an implicit service for the next

hop of a static route, specify that no implicit service is established to the

next hop of the static route. By default the CSS establishes an implicit

service for the gateway address when a static route is defined.

(config)# ip no-implicit-service

3. (Optional) Enable box-to-box redundancy to provide chassis-level

redundancy between two identically configured CSSs.

(config)# ip redundancy

4. (Optional) Set the equal-cost multipath (ECMP) selection algorithm and the

preferred reverse egress path.

(config)# ip ecmp address

5. (Optional) Enable the CSS to forward subnet broadcast addressed frames.

(config)# ip subnet-broadcast

6. (Recommended) Display IP information for the CSS. For example, to

display IP routing information, enter:

# show ip routes

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 185 186

Brak uwag

Cisco 11503 - CSS Content Services Switch Dokumentacja Strona 148