Cisco Ethernet Connectors Jackscrew Instrukcja Użytkownika Pobierz pdf

Doc. No. 78-1127-01 Rev. A0

Jackscrew Installation Instructions

(for EIP Ports)

For Cisco Part Number 51-0385-01

This document provides instructions for replacing the slide-type Ethernet connector

locks with jackscrew type connector locks. Typically, Ethernet ports and cable

connectors have either slide-type or screw-type locks, both of which provide strain relief

and secure the cable to the router port. The slide-type lock is most common, and it is

standard on EIP ports.

If your Ethernet cables use thumbscrews rather than posts, you must replace the

slide-type lock with jackscrews before you can connect the cables to the ports.

You can complete this replacement while the EIP is installed and operating in the chassis;

however, we recommend that you shut down an enabled interfaces before you work on

the port.

The sections in this document include the following:

■ “Obtaining Technical Assistance,” page 2

If you encounter installation problems that you cannot resolve, this section provides

instructions for obtaining technical assistance and lists the information you will need

to provide to the customer service or TAC representative when you call

■ “Product Overview,” page 2

A brief illustrated description of the EIP and the two types of cable locks

■ “Prerequisites,” page 4

Safety guidelines to prevent damage to the equipment from electrostatic discharge

(ESD) and the tools and parts you will need for this replacement

■ “Installation,” page 6

Procedures for shutting down interfaces that are already enabled, for replacing the

slide-type lock bracket with jackscrews, and for verifying that you are able to bring

the interfaces back up and resume operation

1 2 3 4 5 6 7 8 9 10

Podsumowanie treści

Strona 1 - (for EIP Ports)

Strona 2 - Product Overview

This document is to be used in conjunction with the Cisco 7000 Hardware Installation and Maintenance publication.APPI, ciscoBus, Cisco Systems, CiscoW

Strona 3 - AC POWER

2Jackscrew Installation Instructions (for EIP Ports)Obtaining Technical AssistanceThis document contains instructions for replacing the slide-type con

Strona 4

Jackscrew Installation Instructions (for EIP Ports) 3The EIP is the 2, 4, or 6-port high-speed Ethernet interface processor for theCisco 7000 router.

Strona 5 - Required Parts

4Jackscrew Installation Instructions (for EIP Ports)Figure 3 Ethernet Interface Processor (EIP)PrerequisitesBefore replacing the EIP connector locks,

Strona 6 - Installation

Jackscrew Installation Instructions (for EIP Ports) 5Required PartsThe following parts are included in each jackscrew replacement kit. Because the ho

Strona 7 - Removing the Slide Lock

6Jackscrew Installation Instructions (for EIP Ports)Note: For safety, periodically check the resistance value of the antistatic strap. Themeasurement

Strona 8

Jackscrew Installation Instructions (for EIP Ports) 7After you have replaced the connector locks, reenable the interfaces by entering thecommand no s

Strona 9 - Checking the Installation

8Jackscrew Installation Instructions (for EIP Ports)Step 4: Repeat steps 2 and 3 for all addition ports that require jackscrews.Step 5: Place the remo

Strona 10

Jackscrew Installation Instructions (for EIP Ports) 9Checking the InstallationTo check the interfaces, you will connect network interface cables to t