Cisco 2948G-GE-TX - Catalyst Gigabit Ethernet Switch Przewodnik Instalacji Pobierz pdf (Strona 67)

3-17

Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide

78-6286-05

Chapter 3 Installing the Switch

Installing the Catalyst 2948G-GE-TX Switch

Attaching the RPS Connector Cover

If you are not using a Cisco RPS with your switch, use the two Phillips pan-head

screws to attach the RPS connector cover to the back of the switch before you

mount it, as shown in Figure 3-13.

Warning

If an RPS is not connected to the switch, install an RPS connector cover on the

back of the switch.

Statement 265

Figure 3-13 Attaching the RPS Connector Cover on the Catalyst 2948G-GE-TX

Switch

Mounting the Switch on a Wall

For the best support of the switch and cables, make sure the switch is attached

securely to wall studs or to a firmly attached plywood mounting backboard.

Mount the switch with the front panel facing up, as shown in Figure 3-14.

1 Phillips pan-head screws 3 RPS connector

2 RPS connector cover

1 2

ATING

100-200V ~

1.6A-0>9A, 50-60 H

DC IN

TS FO

R REM

ER SUPPLY

SPECIFIED

IN M

ANUAL

+12v @

8.5a

98668

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 141 142

Brak uwag

Cisco 2948G-GE-TX - Catalyst Gigabit Ethernet Switch Przewodnik Instalacji Strona 67