Cisco XR 12000 Series Instrukcja Użytkownika Strona 44
- Strona / 148
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
2-14
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
1 Port 10-Gigabit Ethernet SPA Overview
1-Port 10-Gigabit Ethernet SPA LEDs
The 1-Port 10-Gigabit Ethernet SPA has two LEDs, an ACTIVE/LINK LED for the port and a STATUS
LED, as shown in
Figure 2-9.
Figure 2-9 1-Port 10-Gigabit Ethernet SPA Faceplate
Table 2-11 describes the 1-Port 10-Gigabit Ethernet SPA LEDs.
1-Port 10-Gigabit Ethernet SPA XFP Optical Transceiver Modules, Connectors,
and Cables
The 1-Port 10-Gigabit Ethernet SPA supports the following types of optical transceiver modules:
• Single-mode short-reach (SR) XFP module—XFP-10GLR-OC192SR
• Single-mode intermediate-reach (IR) XFP module—XFP-10GER-OC192IR
• Single-mode very-long-reach (ZR) XFP module—XFP-10GER-OC192LR
• Multi-mode short reach (SR) XFP module—XFP-10G-MM-SR
Cisco Systems qualifies the optics that are approved for use with its SPAs. As of Cisco IOS XR
Release
3.4.1, the above-listed small form-factor pluggable (XFPs) are the only optical transceiver
modules qualified for use.
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns (nominal diameter
is approximately 10/125 microns) to connect your router to a network.
Figure 2-10 shows the cable type for use with the XFP optical transceiver module on the 1-Port
10-Gigabit Ethernet SPA.
1 ACTIVE/LINK LED 2 STATUS LED
STATU S
122151
ACTIVE/LINK
SPA-1X10GE-L-V2
1 2
Ta bl e 2-11 1-Port 10-Gigabit Ethernet SPA LEDs
LED Label Color State Meaning
ACTIVE/LINK Off Off Port is not enabled by software.
Green On Port is enabled by software and the link is up.
Amber On Port is enabled by software and the link is down.
STATUS Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good, and the SPA is being configured.
- Hardware Installation Guide 1
- CONTENTS 3
- Contents 4
- Changes to This Document 9
- OL-17438-04 10
- Objectives 11
- Organization 11
- Related Documentation 12
- Interface Processors 13
- Router Hardware Installation 14
- Supported Platforms 15
- SIP Summary 16
- Cisco XR 12000 SIP-600 LEDs 18
- Cisco XR 12000 SIP-401 LEDs 21
- Cisco XR 12000 SIP-501 LEDs 24
- 10-Port Gigabit Ethernet SPA 26
- Cisco XR 12000 SIP-601 LEDs 27
- Port Adapters 31
- SPA Summary 32
- Bandwidth Oversubscription 33
- Bandwidth Oversubscription 34
- Figure 2-4 RJ-45 Connector 40
- 8-Port FastEthernet SPA LEDs 41
- RJ-45 connector 42
- XFP Connections 45
- SPA-2X1GE 47
- SPA-2X1GE-V2 48
- SFP Module Connections 49
- SFP-GE-S Modules 51
- SFP-GE-L Modules 51
- SFP-GE-Z Modules 51
- SFP-GE-T Modules 51
- SPA-1XCHSTM1/OC3 60
- Figure 2-18 SFP Optics Module 62
- Figure 2-19 LC Type Cables 62
- Figure 2-21 SFP Optics Module 64
- Figure 2-24 SFP Optics Module 67
- Figure 2-25 LC Type Cables 67
- Connector, and Cables 70
- Figure 2-28 SPA Mate Cables 71
- OC-192 Module Connections 74
- Mate Interface Cables 75
- Figure 2-33 SFP Optics Module 78
- Figure 2-34 LC-Type Cable 78
- OC-3 Module Connections 79
- SPA-8XOC12-POS 80
- OC-12 Module Connections 84
- SPA-1XOC12-POS 85
- Figure 2-40 LC-Type Cable 88
- Figure 2-43 SPA Mate Cables 91
- SPA-2XOC48-POS/RPR 92
- Modules, and Connectors 93
- OC-48 Module Connections 94
- 2-Port OC48-POS/RPR SPA LEDs 95
- Connectors 97
- IPSec VPN SPA LEDs 98
- Figure 2-51 SFP Optics Module 100
- Figure 2-54 SFP Optics Module 103
- SPA-2CHT3-CE-ATM 104
- Cable Installation 108
- SPA Cable Pinouts 108
- RJ-45 Cable Pinouts 111
- Patch Panel Cabling 111
- Connectors, and Cables 114
- ACTIVE/LINK 116
- XFP Module Connections 117
- SPA Interface Processor 119
- Telephone Wiring Guidelines 120
- Laser/LED Safety 120
- Required Tools and Equipment 122
- Processor 123
- Removing and Installing a SIP 124
- Removing a SIP 125
- Installing a SIP 127
- Handling SPAs 129
- Online Insertion and Removal 130
- SPA Installation and Removal 130
- Cleaning Optical Devices 131
- Checking the Installation 132
- Checking the Installation 133
- Troubleshooting the SIP 137
- Using debug Commands 137
- Packing a SIP for Shipment 138
- Packing a SPA for Shipment 139
- Packing a SPA for Shipment 140
- GLOSSARY 141
- Glossary 142
- Numerics 143
Powiązane produkty i podręczniki dla Sprzęt komputerowy Cisco XR 12000 Series
(10 strony)
(546 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.071 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji