Cisco PIX 506 - Firewall Przewodnik Instalacji Pobierz pdf (Strona 9)

PDM version 2.0 and higher releases include a Startup Wizard for initial configuration. Follow these steps

to load PDM and use the Startup Wizard:

Step 1 Use an Ethernet cable to connect your PC to the inside port (Ethernet 1) on the rear panel of

the PIX Firewall.

Step 2 Configure your PC to use DHCP (to receive an IP address automatically from the

PIX Firewall) or assign a static IP address to your PC by selecting an address out of the

192.168.1.0 network.

Note The inside interface of the PIX Firewall is assigned 192.168.1.1, so choose a different

IP address.

Step 3 Check the ACT LED on the rear panel of the PIX Firewall (see Table 2 on page 6) to verify

that your PC has basic connectivity to the inside port (Ethernet 1). When connectivity occurs,

the ACT LED next to the port lights up solid green.

Step 4 To access the Startup Wizard, use a PC connected to the inside port and enter the URL

https://192.168.1.1/startup.html into your browser.

Note It is very important to enter the “s” in “https://192.168.1 .1,” which indicates

a secure connection. If you enter “http://192.168.1. 1” without the “s ” in

“https,” you cannot access the PIX Firewall.

Step 5 Accept the certificates and follow the instructions in the Startup Wizard. For online help, click

the Help button at the bottom of the Startup Wizard window.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Brak uwag

Modele	Rodzaj dokumentu
KFC-W3010	Instrukcja Użytkownika Kenwood KFC-W3010 User Manual [es] , 2 strony
KFC-XW1224D	Instrukcja Użytkownika Инструкция по эксплуатации Kenwood KFC-XW1224D, 2 strony
KFC-S502P	Instrukcja Użytkownika Инструкция по эксплуатации Kenwood KFC-S502P, 2 strony
KSC-8803	Instrukcja Użytkownika Kenwood KSC-8803 User Manual, 2 strony
KSC-9903	Instrukcja Użytkownika Kenwood KSC-9903 User Manual, 2 strony

Cisco PIX 506 - Firewall Przewodnik Instalacji Strona 9