Cisco 3526 Dokumentacja Pobierz pdf (Strona 62)

4-8

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Chapter 4 Configuring Unchannelized mode for the Cisco PA-MC-2T3+

Configuring an Unchannelized T3 Link

Examples of MDL Message Configuration

Examples of configuring MDL messages follow:

• Enter interface configuration mode first.

The example that follows is for a port adapter on a VIP in interface processor slot 1:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)# interface serial 1/0/0

Router(config-if)#

The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)# interface serial 1/0

Router(config-if)#

• Enable the MDL path message transmission as follows:

Router(config-controller)# mdl transmit path

• Enable the MDL idle signal message transmission as follows:

Router(config-if)# mdl transmit idle-signal

• Enable the MDL test signal message transmission as follows:

Router(config-if)# mdl transmit test-signal

• Enter the equipment identification code as follows:

Router(config-if)# mdl string eic router A

• Enter the location identification code as follows:

Router(config-if)# mdl string lic tst network

• Enter the frame identification code as follows:

Router(config-if)# mdl string fic building b

• Enter the unit identification code as follows:

Router(config-if)# mdl string unit abc

• Enter the facility identification code to send in the MDL path message as follows:

Router(config-if)# mdl string pfi string

• Enter the port number to send in the MDL idle signal message as follows:

Router(config-if)# mdl string port string

• Enter the generator number to send in the MDL test signal message as follows:

Router(config-if)# mdl string generator string

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 129 130

Brak uwag

Cisco 3526 Dokumentacja Strona 62